DL Download | Alarm Lock – Top download categories

Looking for:

Dl windows download free. Alarm Lock: Software Downloads

Click here to Download

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Firmware for Gateway V3. Gateway Firmware for V3. For DL-Windows 4. In this situation, simply request another Gateway Status update from the Gateway Configuration Tools menu and manually verify the correct ‘updated’ firmware version 3.

Note: In rare cases, DL-Windows 4. DL-Windows version 5. Refer to the instructions and information detailed in version 3. Then use a valid code or card to ensure access is granted with its valid “access granted” beeps and LED lights. However, if following the valid “access granted” indication you then hear 1 long beep and 5 short beeps, the lock must then be defaulted, re-discovered and the lock profile re-downloaded.

Rest assured that your Gateway always maintains your lock information. Therefore, after defaulting the lock simply re-discover the lock and DL-Windows will manage the “re-configuration process”. Note: The firmware version letter type case “upper case” or “lower case” displayed in the file name may differ and from the case displayed in DL-Windows. Be aware that both letters always denote the same version.

In addition, this firmware supports DL-Windows “Manually Unlock Door” right-click menu option available in versions greater than 5. Supports Version 2 Gateways and Expanders and the Emergency Indicator Lightbar on the inside “protected” side of the door. To Install: Unzip the. Browse for the new. To verify the keypad firmware: Within 10 minutes of the previously described update process, press and hold the “1” key on the keypad for 10 seconds and listen for a short beep followed by a long beep.

If following the valid “access granted” indication you then hear 1 long beep and 5 short beeps, the lock must then be defaulted, re-discovered and the lock profile re-downloaded.

To Install this version: Unzip the. When finished, the confirmation screen displays the 64j firmware. In addition, after updating the firmware, manually default the locking device Function 99 as described in the programming instructions. Then, re-discover the lock and perform a full download i. Failure to perform these tasks may cause improper device operation. In the Open screen, navigate to the folder on your computer containing the downloaded.

The firmware will begin to install. Within 10 minutes of cycling power, press and hold the number 1 key. Verify that the red LED flashes “1 short blink” indicates version e. Be aware that both types of letters always denote the same version. Note: When upgrading to Version 4. Delete the DL Windows directory, then install the new version.

Finally, import the database to the new version. Note: Import utility is found in the DL-Windows folder. Next, extract all of the contents of the WinZip file to the same or a newly created folder location. Then in the Setup folder, run ” Setup. Note: Accompanying the DL-Windows 5. When finished, install patch files located on this website search for “DL-Windows V5.

The “AlarmLock. Upgrading from 4. Note: All account files, including the AcctList file must be in the same location. Upgrading from 5. Next, Extract All of the contents of the WinZip file to the same or a newly created folder location again, be sure to ” Extract All “. In the Setup folder, run ” Setup. In the Setup folder, run ” Setu p. The ” AlarmLock. Home Software. Software Downloads. Firmware – Gateway V3. Supports Version 2 Gateways and Expanders.

Also includes other updated keypad programming features. Important: After updating the firmware: A. At the back of the lock, remove the lock housing screw and remove the cover. Take out battery pack and remove battery power by disconnecting the battery pack plug.

With battery power disconnected, short the two white wires Remote Input wires together for 10 seconds to ensure discharge of all capacitors. After 10 seconds, remove the short. Plug in the provided male shunt connector into the yellow wire female connector. With shunt connector connected, re-connect the battery pack. The lock will immediately sound 3 short beeps if these 3 beeps are not heard, then restart at step 3. The lock will then sound more slow beeps, 1 beep for every second it takes to clear the memory.

Lock is ready for programming after 2 rapid beeps are heard and 2 green LED flashes are seen. Download the two firmware. Select Update Lock Firmware from the pop-up menu. Confirm the new “Netpanel” version number located on the Lock Status screen. Software – DL-Windows V3. A legacy version of DL-Windows.

Software – DL-Windows V4. Software – DL-Windows V5. Software House CCure V2. Consumer Support Non-Locking Professionals, click here to get a factory-trained specialist in your area. Visit Our Other Sites.

 
 

DL Tools for Windows Release Software Full Download | Knowledge Center.

 

Varmistaaksesi koneen sammumisen valitse kirjautumisruudulta tai aloitusvalikosta virtapainike ja valitse Sammuta. Jos latasit Windows n ISO-tiedoston, tiedosto tallennetaan paikallisesti valitsemaasi sijaintiin. Napsauta ISO-tiedostoa hiiren kakkospainikkeella ja valitse Ominaisuudet. Haluatko asentaa Windows n tietokoneeseesi? Haluat asentaa Windows n uudelleen tietokoneeseen, jossa Windows 10 on jo onnistuneesti aktivoitu.

Tallenna ja sulje mahdollisesti avoinna olevat sovellukset ja tiedostot. Kun olet valmis, valitse Asenna. PDL 67L. N95x12 83u. ETPLN 63d. PDL 68j. PDL , Networx ,. ArchiTech Firmware – Lock V90b. N90x34 90b. N95x12 83p. PL 59d. PL , Networx ,. PDL 55t. DL 58g. Networx , DL ,. ETDLN 62g. ArchiTech Firmware – Lock V81q. N95xAB v81q. ArchiTech Firmware – Lock V83o. N95x12 v83o. PDL 57i. Networx Firmware – Gateway V3.

DKControl 64t. DL-Windows 5. DL 56k. DL , Networx ,. PDL 55s. PDL 67k. Networx , PDL ,. ArchiTech Firmware – Lock V85a. Windowsin tuoteversio.

Microsoft Office -tuotteet. Kun tiedosto on ladattu, siirry tiedoston tallennussijaintiin tai valitse Avaa tallentava DVD-asema ja kopioi tiedosto DVD-levylle seuraamalla ohjeita. Valitse Asenna Windows. Aloita Windows n asentaminen kaksoisnapsauttamalla setup.

Lataa Insider Preview -esiversioita Windows Insider -sivustosta. Oppilaitosversioita tuoteavain tarvitaan on oppilaitostuotteiden lataussivulla.

 

Lataa Windows 10.

 

PDL 68j. PDL , Networx ,. ArchiTech Firmware – Lock V90b. N90x34 90b. N95x12 83p. PL 59d. PL , Networx ,. PDL 55t. DL 58g.

Networx , DL ,. ETDLN 62g. ArchiTech Firmware – Lock V81q. N95xAB v81q. ArchiTech Firmware – Lock V83o. N95x12 v83o. PDL 57i. Networx Firmware – Gateway V3. DKControl 64t. DL-Windows 5. DL 56k. DL , Networx ,. PDL 55s. PDL 67k. Networx , PDL ,. ArchiTech Firmware – Lock V85a. N90x12 85a. N95x12 83L.

ArchiTech Firmware – Lock V81o. Haluatko asentaa Windows n tietokoneeseesi? Haluat asentaa Windows n uudelleen tietokoneeseen, jossa Windows 10 on jo onnistuneesti aktivoitu.

Tallenna ja sulje mahdollisesti avoinna olevat sovellukset ja tiedostot. Kun olet valmis, valitse Asenna. Tarkista seuraavat seikat tietokoneessa, johon haluat asentaa Windows n: tai bittinen suoritin. Windowsin kieli. Windowsin tuoteversio. Tarkista seuraavat seikat tietokoneessa, johon haluat asentaa Windows n: tai bittinen suoritin. Windowsin kieli. Windowsin tuoteversio. Microsoft Office -tuotteet.

Kun tiedosto on ladattu, siirry tiedoston tallennussijaintiin tai valitse Avaa tallentava DVD-asema ja kopioi tiedosto DVD-levylle seuraamalla ohjeita. Valitse Asenna Windows. Aloita Windows n asentaminen kaksoisnapsauttamalla setup.

 
 

NAPCO Technical Library – Latest WinRAR and RAR Versions

 
 
Alarm Lock’s DL-WINDOWS software now available as a free download. Oct. 29, Software enables easier and faster programming and access. Software – DL-Windows V (Full-LATEST) · DL-Windows vzip, DL-Windows, , 5/6/21, DL-Windows,, Download.

Category: bi4